Current Position:Home > WRT120N- Cannot reset default settings

WRT120N- Cannot reset default settings

Update:12-10Source: network consolidation
Advertisement
I've browsed the forums for a possible solution to this problem.  I've tried holding the reset button for 30 sec/1min, followed by powering down for the same amount of time.  I've also tried pinging the default 192.168.1.1, and got a few messages of "Destination cannot be reached" before the message of request timed out.
I set the router to be a wireless access point on my school network, but the network is not recognizing the modem as part of its system.  I'm hoping to start the process from scratch (I've set up numerous routers in the same manner, this one is causing me lots of problems).  Any advice? 

The Best Answer

Advertisement
Do not connect the modem to the router...Only connect the computer to the router.Disable the firewall and anti-virus on the computer...Hard-reset the router again.power cycle the router...On the computer assign the static ip address 192.168.1.10,subnet 255.255.255.0 and gateway as 192.168.1.1...Now,go to the command prompt and try ping the gateway again...
  • WRT120N- Cannot reset default settings Update:12-10

    I've browsed the forums for a possible solution to this problem.  I've tried holding the reset button for 30 sec/1min, followed by powering down for the same amount of time.  I've also tried pinging the default 192.168.1.1, and got a few messages of

  • Resetting default settings in ps cc 2014 Update:11-30

    I need to reset my photoshop.  It is not functioning very well.  When I follow all the instructions, I don't get a pop up box to reset my settings.  Instead I get a whole window about getting started etc.  Nothing about resetting the program.  Ctl, A

  • Reset default settings on vi termination Update:11-30

    I wish to reset my controls to the default settings on termination of the vi. I have set the default values in the properties field. When I restart my vi the settings at termination are those at next run of vi. Two controls I wish to reset to default

  • Reset Default Settings? Update:11-30

    I accidently dragged a window somewhere and now it won't preview the video anymore. I checked, Preview was checked but it doesnt shwo the video, can anyone help m or tell me how to reste defualt settings?> I did something that has caused very poor qu

  • Reset default settings on adobe flash player Update:11-30

    please helpIf you have set a default value for all the controls on the FP. then you can create and invoke node for the entire vi.(see examples) If you wish to just have a couple of your controls set to default then all you have to do is right click o